Company:
Phoenix Closures
Location: Bloomington
Closing Date: 20/10/2024
Hours: Full Time
Type: Permanent
Job Requirements / Description
- Clean and inspection of all components
- Repair any damages as directed by Tool Room Supervisor
- Install, replace, and maintain water and hydraulic fittings
- Troubleshoot, repair and maintain HR manifolds, controllers, and cables
- Perform tooling changeovers only after reviewing the applicable Mold Recipe Document (cores, strippers, cavities, gate inserts, and plates)
- Prior to production - test water and HR systems, including controllers
- Replace "O" rings and seals
- Lubricate molds
EDUCATION AND TRAINING:
POSITION SUMMARY:
- To maintain molds and tooling for use in production; to perform mold and tooling changes safely and efficiently; to keep Tool Room Supervisor informed of the condition of all molds and components.
- Performs scheduled maintenance on molds as directed by the Tool Room Supervisor;
- Maintenance tasks include but are not limited to:
- Clean and inspection of all components
- Repair any damages as directed by Tool Room Supervisor
- Install, replace, and maintain water and hydraulic fittings
- Troubleshoot, repair and maintain HR manifolds, controllers, and cables
- Perform tooling changeovers only after reviewing the applicable Mold Recipe Document (cores, strippers, cavities, gate inserts, and plates)
- Prior to production - test water and HR systems, including controllers
- Replace "O" rings and seals
- Lubricate molds
- Transport and manipulate molds by use of fork lifts and overhead cranes;
- Documents condition of tooling; informs supervisor of any major damage to mold or tooling;
- Checks knock out rods, chute for mold, water lines/hoses, etc.;
- Returns tooling and components to their assigned locations;
- Hooks up / unhooks water, chute, and cylinder (if rack mold) for mold changes in accordance to engineering approves prints;
- Installs / removes knock out rods, conveyors, spinner bowls, side shields, and thermolator;
- Hooks up / unhooks controller, (if hot runner mold);
- Constructs side shields, chutes, or knock out rods as required;
- Adheres to all department safety procedures;
- Undergoes training and becomes proficient in all tool room related Phoenix Work Instructions;
- Participates in additional training to improve knowledge and hands-on skill levels.
- Responsible for following all Food Safety related policies and procedures;
- Responsible for following all Safety Rules, policies, procedures and work instructions.
EDUCATION AND TRAINING:
- Minimum High School diploma or equivalent; ability to read and understand blueprints; good reading and writing skills; ability to use micrometer, ruler, and caliper; fork lift and man lift certifications required.
- Minimum 3 years of related experience.
- Lifting or Carrying (0-35 lbs. typically 0-15% of the day);
- Simple Grasping (0-15%) - sorting, filing;
- Fine Manipulating (30-70%) - typing, computer work.
- Personal Computer, calculator, telephone, portable electronic devices.
- Production Department Managers;
- Molding and Lining Maintenance personnel;
- Corporate Tooling Engineer;
- Customer Service; Process;
- Design Engineering personnel;
- Production Planners;
- Vice President of Operations Support;
- Director of Engineering.
- Tooling Supervisor.
Share this job
Phoenix Closures